MB2 - V + V 1350

Ausgestattet mit den folgenden Arbeitseinheiten: XVS-85

Technische spezifikation:

General technical data: Useful working width mm 1350 Brush units service side (standard) Left hand Standard working thickness mm 0,5÷60 Constant pass-line height of feed table from floor mm 900 Rubber-covered roller, positioned in front of machine; it's connected to emergency switches; activated it causes the stop in emergency and the thickness opening to prevent damages. Machine frame: Built with rectangular profiled steel elements that give a very high rigidity to the frame; main motors up to 30 kW are positioned inside the frame Transmission from main motors to working units with belts and pulleys Machine finish paint -Frame and base, all visible motors and drives, internal part inside the covers RAL 5010 -Doors, panels and switch cabinet, external electric cabinets RAL 7035 -Safety cut-out bar RAL 3020 -Transport elements RAL 2004 Machine manufactured per CE regulations, directive CE 2006/42 Pressure units: Motorized pressure units positioned in front and rear of each working unit complete with rubber covered rollers oil/heat resistant. Feed system: Feed system with rubber covered rollers and chromium coated "billy rollers" under each working unit. Drive unit with motorvariator controlled by inverter for feed speed variation Feed speed variable in continuous from - to m/min 0,3÷6 Manual system for inversion of feed direction with automatic lifting of working units. R300E - Feed table extension in machine front side with rubber covered idle rollers, length mm 300 R300U - Feed table extension in machine rear side with electric safety system and with rubber covered idle rollers, length mm 300 1st Top Working unit: XVS/85 - Vertical cross brushing unit. Main motor controlled by Inverter.Motorized height adjustment. Ø 85 mm Inverter for oscillation of XVS unit 2nd Bottom Working unit: XVS/85 - Vertical cross brushing unit. Main motor controlled by Inverter.Motorized height adjustment. Ø 85 mm Inverter for oscillation of XVS unit Electric plant: Electric plant in a cabinet in the front side of machine, includes a main switch. Push button and control panel at same side of sanding belt insertion, with a series of leds for the automatic diagnostic of faults. IP54 - EN60204-2 No.2 - Electric plant built on standard CE rules Volt 400 - Hz 50 Auxiliary circuits of electric plant Volt 24 DC Pneumatic plant: Pneumatic plant complete with filters - oil/air nebulizer - normal pressure of operation at bar 6 Safety pressostat with machine stop when the air pressure drops below a minimum bar 5 Programming and control units: VT-11 - Digital thickness read-out for 1 axe, with decimal accuracy. PLC-Vision A - Computerized system for machine programming, with visualization of various settings via touch-screen colour monitor.Possibility to store up to 250 complete working programs. Machine has to be connected to a suction system

Wir verkaufen nur neue und originelle Produkte!